info

[spinzella]

new seedling 2 round leaves and 4 saw leaves next 2 just starting to show. seed started root and I put it in rapid rooter then into pot with soil after root came out bottom of rapid rooter about inch and a half. have curly flourecent down close to it. stem and leaves doing great not stretching and looks great. using straight water. today one of the first and one of the 2nd saw leaves have large brown spots. 3rd set of saw leaves that are just starting and base of others look almost black. its a feminized carmelicious. any info what is going on and is it bad?

 

[Royal Nugs]

Did you check the ph of your water? What kind of water are you using?

 

[spinzella]

hi royal haven't checked ph just using water out of tap. about a week out till I switch her to the hydroponics and the last 3 have been clones which did real well. this is my first from seed given the clones and right into buckets. using sensi grow and bloom and if my water has ph problem the sensi must correct that

 

[Tika]

Your plain water must be pHed. Not sure what your recommended pH is for soil (I'm in coco coir so I pH to 6.). Also pics are always useful.

 

[Royal Nugs]

Some pictures would be great, but I always suspect a PH issue when seedlings get spots. Some strains are more sensitive to PH than others. Also, it's a seedling so extra care must be taken. I prefer distilled water until they have a few nodes under their belt. I'd adjust your water to 6 and hope for the best.

Pictures would be great...

 

[kingfish]

If you have searated leaves, they need light. Keep PH between 6 and 7, very important.

 

[Potted]

Optimum ph is 6.5 for soil grows makes everyone happy it can change a little but must stay in range or lockout will happen

 

[insomniaczzz]

since you are switching to hydro, spend a few bucks for some bottled spring or distilled water until you make the change. pH is always within range that way.