What's new
GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.

Bowl training method x4

Cronk

New member
my last grow I used something called the Bowl method or Stadium method of training. This is where you top the 6th node and take the remaining 5 branches and pull them out with wires in a circle shape, creating a bowl shape in the end. You then lolipop the center and concentrate on the colas, pulling them as needed to maintain equal height, resulting in 10 thick main colas with little fluff.

imma try again with 4 plants. 3x Dinamed CBD+ and 1x Royal Queen Critical

2.5 gallon fabric pots
Mega Crop at 1/2 strength
Cal-mag
SNS 604B (freebie)
Greeenleaf Bud Explosion at flower

Last time I grew one plant this way and was a bit too strong with the nutes. The plant also had a kink in the stem that helped me out keeping it low to the ground. I'll have to recreate this with wire so the main stem is short and all 10 colas are close to the same height.

I might also top the 7th node and clip the first as this one is usually smaller. I also flowered too soon resulting in a short plant. I'll want to give this one about 4.5 weeks in veg. stretch was only about a 2 factor. I harvested early when all or most trichomes were cloudy, a few clear and as few as possible amber. The idea is to get the most cloudy as this is where the CBD is most. In doing this I lost the last week of plump. I only got 2.8 ounces. I'll do the same this time but hopefully will have more height for yield.

This time I already have a challenge with the seedlings, which is usually my problem. I used roto rooters for the fist time and just dropped the seeds in the holes. They all grew upside down, roots straight up, leaves down inside the rooter. I had to right all of them, pulling them out and re-seating the roots into the rooter. They may not all make it. pretty stupid on my part, I should have used a paper towel to germ and dropped the seeds with sprout in afterward.

Anyway, I hope to improve the process. I'll post here when I can
 

Attachments

  • photo86414.jpg
    photo86414.jpg
    2.3 MB · Views: 0
Last edited:
This seems like an (almost) stress free alternative to manifolding. I’d be interested to see a side-by-side of the two techniques. Sub’d!
 
I’ll definitely check that out, thanks! Maybe by reading it, I can learn a thing or two and prevent some of the same mistakes that you made. I am doing quadlining on my current grow, which is still in seedling stage. I’m hoping I don’t mess anything up LOL
 
that's why I kept posting, it got so messed up that I figured it would help someone, haha not bad in the end though. 12 oz for 4 plants
 
is a 4 lamp 24" T5 enough to start and veg plants? This is the first time I'm using this exact setup. Slow going.
 

Attachments

  • photo86584.jpg
    photo86584.jpg
    2.4 MB · Views: 0
  • photo86585.jpg
    photo86585.jpg
    1.3 MB · Views: 0
is a 4 lamp 24" T5 enough to start and veg plants? This is the first time I'm using this exact setup. Slow going.

Looking better at the picture sorry I was thinking it was not close enough. But 24" looks great for 4bulb. Your setup is perfect to me. You got this!
 
you're good, The first photo had is farther away. I moved it much closer in the second post. Was asking if it was too close now.
Thanks
 
ok, what's going on here? I'm 2 weeks from dropping seeds and this is where I;m at. No growth since the initial sprout. Health looks weak. These roto rooters are very dense and the roots don;t seem to be penetrating downward. Is this the problem? Am I over-watering, under-watering? too little light? It's 4 24" T5 tube about 14" away.

I'm at a loss. Looks like they're not going to make it.
 

Attachments

  • photo86883.jpg
    photo86883.jpg
    1.6 MB · Views: 0
I don't have a great space for keeping plants alive year round and I'd need another tent to keep everything contained and concealed.
 
Back
Top