Tina and Louise have had a rough couple of weeks. Leaves wilting, pale green, yellow leaves starting at the bottom of the plant and moving up. Thought I was dealing with a nitrogen deficiency caused by a lockout. Turns out it may have been a PH problem caused by mis-calibrated equipment. When I recently calibrated the PH probe for the rez controller not sure what I did, but something happened. That probe was off by 4 points. I run my rez at 5.5 to 5.6 PH and use the controller to set the PH when I mix nutrients. I have a PH pen that I use as well. I noticed the difference but thought the controller probe was correct because I had just calibrated it. Bottom line is the probes are all calibrated in the same solution and now read the same. All of the equipment got a wash and is sparkling.
Without knowing the PH probe was off I tried everything I knew to fix the problem. Today, I finally did a not-recommended for autopots top down flush of 15 gallons each pot with a weak nutrient solution. I verified the flush by run off EC and PH being the same coming out as going in. I put the system back together and as I made a new nutrient solution for the rez, realized the problem with the PH readings. I have been kicking my own ass. I despise that with a white hot passion.
In spite of the PH issues the flowers are getting fatter. I hope to start the PK load in a few more days. I have my fingers crossed I've corrected the problem.
Without knowing the PH probe was off I tried everything I knew to fix the problem. Today, I finally did a not-recommended for autopots top down flush of 15 gallons each pot with a weak nutrient solution. I verified the flush by run off EC and PH being the same coming out as going in. I put the system back together and as I made a new nutrient solution for the rez, realized the problem with the PH readings. I have been kicking my own ass. I despise that with a white hot passion.
In spite of the PH issues the flowers are getting fatter. I hope to start the PK load in a few more days. I have my fingers crossed I've corrected the problem.

Comment