Hello amigos,
well here i am again with some issues. There is some holes in leaves appearing. Mostly on top leaves and new growth. I have looked carefully and cannot find any visible bugs/pest. I did order a jeweler loupe but wont be here for a few days. Until then im not too sure what to do.
5 Gallons smartpot in coir
Under vipar led 450w at apprx 36 inch. (18/6 cycle)
temp 23-26 C
Fertigation 2x daily.
Ph between 5.6-6.3 ish
Just started to measure PPM, slowly reaching 900ppm to get a higher ppm run-off.
I added a second fan in an attempt to deter bugs of hanging around the plant.
Plant is still small for a month in (about 6 inch) but it had a rough start with light burns early seedling and fertigation frequency ect, so i believe its just the results of the learning curve,
Any input appreciated.
1- Hole that got bigger, from a pin head to this size in about a week. You can also appreciate yellowish dent in the center of the leaf.
2- Under that same leaf
3- Holes
4- Holes (tear is my fault)
5- Main stem
well here i am again with some issues. There is some holes in leaves appearing. Mostly on top leaves and new growth. I have looked carefully and cannot find any visible bugs/pest. I did order a jeweler loupe but wont be here for a few days. Until then im not too sure what to do.
5 Gallons smartpot in coir
Under vipar led 450w at apprx 36 inch. (18/6 cycle)
temp 23-26 C
Fertigation 2x daily.
Ph between 5.6-6.3 ish
Just started to measure PPM, slowly reaching 900ppm to get a higher ppm run-off.
I added a second fan in an attempt to deter bugs of hanging around the plant.
Plant is still small for a month in (about 6 inch) but it had a rough start with light burns early seedling and fertigation frequency ect, so i believe its just the results of the learning curve,
Any input appreciated.
1- Hole that got bigger, from a pin head to this size in about a week. You can also appreciate yellowish dent in the center of the leaf.
2- Under that same leaf
3- Holes
4- Holes (tear is my fault)
5- Main stem
Comment