What's new
By:
GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.

Time to show your grow.

Trizzlers auto from 20/20 Mendocino. Watermelon zkittles x triangle Kush. Closest thing to old school skunk I've found yet.
IMG_20230317_163507248_HDR.jpg
IMG_20230317_163513822_HDR.jpg
IMG_20230317_163530406.jpg
IMG_20230317_163537955_HDR.jpg
 
The nutes I give it are sufficient. I don't need to add to them. If I have a cal/mag deficiency first thing I look at is pH. I'm in mid flower now so can run the pH up a bit which increases the plants ability to take up cal/mag. I brought it up a fraction and have increased my nute ratio to almost 85% of recommended. This should address the minor deficit I'm getting on 2 plants....fingers crossed it's sufficient.
 
Had to dilite them back to a bit...maybe 70% now..nute burn creeping in again. pH had dropped and bumped it back up
 
well after the steam pipe replacement I'm ready for the rest of the girls I am running a trial run with all the lights on, exhaust fan to check the heat fluctuations with the lights on and off the way I regulate the heat is to cycle the exhaust fan on and off and I dont want to put the new babys in there without knowing how the temps are the 6 girls in there now have been in the room for 1 week under a 315 lec left on 24/7 I had 1 midnight mass and 2 Banana Kush autos and 3 LSD autos. The Midnight Mass will be transplanted into a 20 gallon pot .
the third picture is of my green house thats right it doesn't exist any more,it collapsed in the storm Mon,Tuesday and Wednesday, still I think we were way luckier than the folks in Cali. I remember 1 year in Maine were we had tunnels from the front door to the street and wood pile,but I was a kid so it was fun
 

Attachments

  • photo162452.jpg
    photo162452.jpg
    454.8 KB · Views: 2
  • photo162453.jpg
    photo162453.jpg
    462.4 KB · Views: 1
  • photo162454.jpg
    photo162454.jpg
    511.6 KB · Views: 1
I would say try get or borrow a temp gun and check . I assumed 2-3 less than air temp before I checked turns out my garden is almost always 0 offset.
Whatever it is it will significantly change you VPD targets
 
Howdy oldjarhead100 yah fella that's some crappy weather. Real sorry about the greenhouse, I've not put mine up yet but gonna try but i need xtra hands to help me so i'm waiting..........it's been rolled up with the frame now for a year since i moved to this new place. I don't know what it will look like once i try to put the plastic heavy tarps on it, could have holes could be trash. Anyhow, glad your all heated up in the cellar. Can't wait to get the garden planned out, got my carrots and bean seeds also corn this year. Snow tunnels yep poor folks had quite the snow fall in Nor Cal woke them up to what a real winter is. You take care of yourself. :)
 
Bluey 72f-57%-6.2pH. Now 72f-50%-6.2pH i dont swing. two different plants on one res, in one room makes it conundrum.
madman any time you have dead or dying matter you are heading for bud rot.
 
Smallgrow if it's transpiring (the plants alive) it is not a zero offset. It will be 3 to 4⁰F lower if it is transpiring at healthy rates. Your gun is likely not too accurate or maybe your air temp thermometer is reading a tad low....it must be lower....oh..the leaves may be getting baked by the lights..that'll do it.
 
Yes it is a conundrum Mr.furley but that's what you get when your partner likes to keep everything neat and tidy and put all the seeds into one jar.
Thanks for the heads up on your numbers. I did the last lift on the lights yesterday now at 37", temps @ 78⁰F and slowly lowering along with himidity @48%RH.
That strain showing the mag deficiency also showed it on a couple of leaves during veg...I was prewarned
 
Last mouldy harvest Mrs. Bluey did the wet trimming and she did such a great job that not much dry trimming was required. She placed the buds on a fly wire screen about 4' x 3' and we blew air gently across and through it until it was ready for the jars. Probably a tad over dried but we all know what mould does
 
Last winter a storm started peeling off our green house panels, luckily a warm spell followed and we were give time to repair it...Never knew anything about bending wood, but it was required to reinforce the structure...Nice little wall paper steamer with couple of C clamps did the job, along with PL and ton of screws..However your situation looks a bit more extrema...luckily you had Plan B..
 
You must log in or register to reply here.
Back
Top