What's new
GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.

HYDRO Root rot? Or dyed roots?

Adam17

New member
Hello. I’m writing to ask the community to comment on my roots. IE specifically if I have root rot and how they would fix with a sterile res. This is my second grow and first dwc. I wish I would have taken pictures sooner than I did to see if the dark spots were growing. But I didn’t so this is what I have.
my buckets are always between 18-22°C. I’m Canadian(≈66-72°f). I do res changes every week. Past week and a half I’ve been adding 2ml/gal of 29% h202 during res changes and every 3 days. The dark spots don’t seem slimy. The buckets don’t stink. The roots don’t fall apart when I touch them. And as you can see all new growth looks healthy.
Earlier on (week 3 veg) I convinced myself that it was dyed roots from nutrients. But since my last res change the dark spots look almost black. The dark areas seem to be at the top of the water level in the buckets.
I’d like to keep a sterile res this grow, but I’ve accepted if beneficial bacteria (bennies) is the solution I’d give it a try and convert next grow (unless absolutely necessary this grow). I have done extensive research on the web and on this site in regards to root rot and still am uncertain if I have it. Take a look. Tell me what you think. Remember I’m a newb and prefer a sterile res.
thanks to all who comment
 

Attachments

  • photo122028.jpg
    photo122028.jpg
    2 MB · Views: 1
  • photo122029.jpg
    photo122029.jpg
    1.9 MB · Views: 1
  • photo122030.jpg
    photo122030.jpg
    2.2 MB · Views: 1
  • photo122031.jpg
    photo122031.jpg
    1.9 MB · Views: 1
  • photo122032.jpg
    photo122032.jpg
    2.1 MB · Views: 1
  • photo122033.jpg
    photo122033.jpg
    1 MB · Views: 1
  • photo122034.jpg
    photo122034.jpg
    1.6 MB · Views: 1
  • photo122035.jpg
    photo122035.jpg
    2 MB · Views: 1
  • photo122036.jpg
    photo122036.jpg
    2.4 MB · Views: 1
Your plants look nice an healthy, to me, doesn't look like any root rot I've seen on here, if it is must be just starting.
I don't do hydro, but I've seen rot before, especially if yours doesn't smell or is slimy.
Somebody does hydro will be on here in a few to help you much better.
Nice plants.
 
2ml/gal of 29% h202 Hydrogen Peroxide ? If so I don't think you want to do that it kills off the beneficial microbes as well as the bad ones. Take what I said with a grain of salt I'm no scientist and I'm high.
 
Right on. Thanks for all the feed back. I tend to over think things when shit in my garden isn’t perfect. Usually my solution is to throw money at the problem until it goes away. But that get tiresome and expensive.
 
Roots should not be dark and twisted. That is the start of root rot. They will continue to grow with root rot if it doesn’t get to bad but it will affect your yield. Nute stained roots look like they are steeped in tea and not twisted. Check your reservoir temperature should be about 68f and use some beneficial microbes to keep algae down and help the roots tolerate higher res temperature
 

Attachments

  • photo121336.jpg
    photo121336.jpg
    113.9 KB · Views: 1
One consistent trait I have found wit the start of root rot is the little side hairs seem to be glued down to the side of the main root (Along with being discolored)
I start adding a double dose of Hydroguard (4ml per gal)..
Your plants look stained, but could use a treatment of Hydro, does not hurt the plant and may head off any root rot starting.
 

Attachments

  • photo121699.jpg
    photo121699.jpg
    1.8 MB · Views: 1
  • photo122780.jpg
    photo122780.jpg
    2.4 MB · Views: 1
  • photo122782.jpg
    photo122782.jpg
    2.7 MB · Views: 2
Last edited:
I am a newbie too and have been using Hydroguard from the start of my first grow. I am in week 6 of flowering and have had similar reservoir temps as you. Roots are still all white. I am curious as to why you prefer a sterile reservoir over using Hydroguard.
 
Hydroguard is very expensive in Canada. And I’d prefer to keep my 2nd grow as simple as possible. I will likely give it a try in future grows. But wanted to see the results in a sterile res this time.
 
Back
Top