What's new
By:
GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.

HELP! New grower, bubbleponics, seedling drooping

A

Aevin1387

New member
I started my first grow last week. February 27 I started germinating my seeds using the paper towel method[1], one seed of three sprouted (one apparently disappeared) and on March 1 I transplanted the germinated seed into a cut open rapid rooter, and placed in my DWC bucket.

The bucket had been prepared with 2 gallons of water at PH 6, using a mix of 1/4 tsp per gallon of FloraMicro, FloraGro and FloraBloom, and 2ml per gallon of hydro guard. Everything went fine at first, see pictures. I actually meant to post all of the pictures except the drooping one yesterday, but my account was approved today and as of writing, the seedling has now dropped down entirely.

While I did move things around yesterday to get better airflow and temp/humidity control, I also did my first weekly water swap yesterday. Not sure if either was the cause.[2] Temperature and humidity are generally 73-77 F, 46-50%

I’ve attached some photos, all photos with comments at https://imgur.com/a/mG4b9rj

[1] I tried three times germinating inside a rapid rooter, with a new bag each time,
[2] Yes, I know, change only one variable at a time.
 

Attachments

  • photo99083.jpg
    photo99083.jpg
    2.8 MB · Views: 3
  • photo99084.jpg
    photo99084.jpg
    4.5 MB · Views: 3
  • photo99085.jpg
    photo99085.jpg
    4.5 MB · Views: 3
It looks pretty leggy like its reaching for light. What kind of lighting are you using and how far away do you have it? Might need to move it a little closer. You could probably prop the seedling up with a little stake, or maybe even bury your rooter a little deeper and gently surround some of the seedling with the hydroton pebbles.
 
NickyChicks said:
It looks pretty leggy like its reaching for light. What kind of lighting are you using and how far away do you have it? Might need to move it a little closer. You could probably prop the seedling up with a little stake, or maybe even bury your rooter a little deeper and gently surround some of the seedling with the hydroton pebbles.
Click to expand...

I’m using a Qb288v2 clone, at near max power, around 30 inches away. I’ve dropped it down to 24 inches and propped up the seedling with some of the hydroton rocks, as well as burying the cube a bit further.
 
Ok so here’s a great idea.. let the seedling lean back down naturally.. lower the light to 18 inches the plant will grow more sideways then tall.. this is actually a known and used form of training coupled with toping it will be nice.. but I agree it’s a light issue it’s not close enough..
 
That's happened to me a lot. They always get back up. I usually plan on it and put a stick in beside it support it if needed. Seeds are all different. My lights are always the same but some pop up tall and some not so tall. Good luck !!
 
It looks like there may have been a couple of issues from what I can see. When you first put the rooted seed into the clay, did you have your fans already running, with light breeze across the top? I use to get this when I would start the seeds elsewhere, let them grow a bit then transplant into the grow room. The fans would knock them over but usually they would recover.
Also are you watering from above daily? I see the clay is moist but you may have knocked it to the side.

Looks like a hell of a nice start!
 
You can drop your light height lower and decrease the intensity to minimum. Your seedling doesn't need all that light. Maybe bring the light down to 18 inches or so and keep an eye on it. Are the roots growing through your cube?
 
Agree with this.. I started in soil.. but prefer water now:. It’s a labor of love .. I’d be lost if I grew in soil again if you have any questions just ask and I’ll answer the best I can
 
You must log in or register to reply here.
Back
Top