Neut burn?

[Jamrasta]

Is this nutrient burn or something else?

LED light.
sorry I can’t remember the strain but it’s either
Cheese or Northern Lights
Currently week 8 or 9 veg.

It’s the first time I have used this bio feed. I got it as a gift from a friend so thought I would try it out.

Unless someone tells me otherwise I think I need to flush with plain water and remove the yellowing leaves right?

I followed the dosage suggestions on the bottle too btw. So I’m not sure if neut burn is what I’m looking at here.

thank you in advance

 

[PLreef]

Can you take pics in normal light? Really hard to make out the issue on the leaves.

 

[Jamrasta]

Here you go ...
I took the worst leaves off already but here’s photos of them. And how it looks now I removed the bad ones.
They have only been off the plant around 10 mins

 

[Rwise]

I say it to much, whats the PH? To me this reads as a root/PH issue and about to get worse.

 

[Jamrasta]

I say it to much, whats the PH? To me this reads as a root/PH issue and about to get worse.

I need to invest in the PH reader pen.
I’ve been using the strips which change colour and it’s usually between 6 & 7.
although not accurate enough I know.
I shall do another check now and let you know what comes back.
thanks for the advice.

 

[Jamrasta]

I just noticed there seems to be a strong smell of sulphur. Like I have a match stick in there or something.

I never noticed this smell before. Is that something to worry about too?

 

[D.A.A.S.69]

If you got everything else pretty much right, like ph, an stuff, I'd say it looks like led, bleaching,
What type light are you using and how close is it?

 

[D.A.A.S.69]

I hear you man, Rwise you can't ask what the ph is to much, cause that's normally the problem, either that or bugs, most of the time.imo

 

[Jamrasta]

If you got everything else pretty much right, like ph, an stuff, I'd say it looks like led, bleaching,
What type light are you using and how close is it?

It’s a 600W full spectrum LED light.
Around 50-60 cm above the top leaves. (It’s what the manual said)


other info -

Growing in a coco / perlite mix

I don’t water the plant according to a schedule, I do the knuckle test and water when I think it’s needed.

P/H strips are still showing as ok levels. I tried a few and all show same result.
6/7 ph is ok for coco soil right?

I might move the light a little higher just to see if anything changes.

 

[SoOrbudgal]

Good plan with raising the light

 

[D.A.A.S.69]

In coco you want your ph between 5.5-6.5,
6.0-7.0ph, for soil.

 

[D.A.A.S.69]

Are you watering to runoff everytime you water?
In coco you need to check your runoff water too.

 

[Rwise]

D.A.A.S.69 And thats the other one, if the leaves are clawed look for bugs.

 

[Rwise]

I just dropped $308. on a Bluelabs combo meter, now to learn how to use it, LOL