What's new
GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.

LST beginning question

Randy2310

New member
Is this the right size to begin LST?

Somango XXL auto flowers from Nirvana in 2 gallon fabric pots. 2x2 tent. I could just let them grow on their own but if I can increase yields I would.
 

Attachments

  • photo161346.jpg
    photo161346.jpg
    4.1 MB · Views: 1
Time for lst! Bend them down, no breaking allowed, between two large fan leaves, try to get angle least a 45 degree bend. Let that set for two days then do it to the new growth. When new growth starts at node 2 and three then bend it 90 degrees away from the center stalk to allow light in. Keep going with notes 4 and 5 until two or three weeks into flower. Goal is a canopy with all branches at the same height.
 
How old are they and what type of LST would you attempt at this point?
​

Just shy of 2 weeks. The largest one broke the soil on 1/22 and the other 3 sprouted on 1/23. Somango XXL autoflowers from Nirvana. Just bending branches so the lower ones grow up and form a canopy.


Time for lst! Bend them down, no breaking allowed, between two large fan leaves, try to get angle least a 45 degree bend. Let that set for two days then do it to the new growth. When new growth starts at node 2 and three then bend it 90 degrees away from the center stalk to allow light in. Keep going with notes 4 and 5 until two or three weeks into flower. Goal is a canopy with all branches at the same height.

Thank you! I wasn't 100% sure when to start. A bit nervous to LST properly especially all 4. All my past successful grows were in space buckets and I hadn't had success with the tent yet.
 
Hello fellow auto newbie. I'm not a expert and hope you don't mind me posting some LST autos i just did. I've not done any topping or pruning of leaf and not tied the branches down just the main stalk.
I used a anchor metal fabric hook to hold the stalk into the soil while i bent it down so as to not uproot. I wait a couple days adjust for it growing an use more hooks to lay it down further but you need to begin now as those get real stiff by 30days an easy to snap off. Mine were as old as yours when i began, they are 32days old now and stiff brittle branches so i'm done with playing with them LOL Best of Luck
 

Attachments

  • photo161233.jpg
    photo161233.jpg
    2.9 MB · Views: 2
  • photo161235.jpg
    photo161235.jpg
    2.9 MB · Views: 1
  • photo161301.jpg
    photo161301.jpg
    3.8 MB · Views: 1
After much trial and error with my autos, I now wait for a mature fifth node before I clear out under four and crank them down.
Nice looking plants and good growing.
 

Attachments

  • photo137203.jpg
    photo137203.jpg
    1.7 MB · Views: 3
  • photo155211.jpg
    photo155211.jpg
    3.3 MB · Views: 2
The way one sets the plant up with early topping is crucial. Once they start to grow back let them get big enough to work with, for example the branch should be long enough to over hang your pot so you can tie it down. Might be a good idea to keep an eye on the rigidness of the branches you are going to work with..Also once the plant starts to fill out and you are still performing LST, always have a good look before walking away..I broke a main branch that was near by, but did not see it until the next day..Too Late..
 
My current situation. I’ve started LST but not sure which way/branches to tie down next. I feel like all I did was get it to grow to one side.
 

Attachments

  • photo161435.jpg
    photo161435.jpg
    4.2 MB · Views: 2
Yes, the plant will grow sideways. Just keep working (slowly) on bending the stalks farther on the new growth. Get the bottom branches pulled down and out to the side and work bending down branches higher up before they get stiff. Again, the goal is get all the tops at the same height. Edit: added pics started with j-hooks then used kabob skewers.
 

Attachments

  • photo158547.jpg
    photo158547.jpg
    1.7 MB · Views: 1
  • photo158579.jpg
    photo158579.jpg
    1.6 MB · Views: 2
  • photo159557.jpg
    photo159557.jpg
    6 MB · Views: 1
Last edited:
As the branches on the sides of main stalk get longer you get shepards hooks upside down J i make them out of anything but that's how i do it just like the main cola stalk. Try an tie them " out " gently toward blank areas. Look at pics google them.
 
Last edited:
Back
Top