GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.
How to build my grow space.
- Thread starter Anoney
- Start date
Smokesteve
New member
With the space that small I think you may find it could be easier to do veg in the entire space then switch to 12/12 in the entire space rather than having left and right. Time will tell though good luck.
RagWeedDWC
New member
I'm currently growing in a space almost exactly like yours (You can see in my journal), the comments about needing more flowering room is spot on. I currently clone, store mothers, and veg on one side, and flower on the other. I use a 270w in veg and a 300w in flower (Had a 1000w but it gave off more heat that a new boiler).
My biggest issue is being limited to two flowering plants and trying to find space to train the next flowering group in the same space Im trying to store clones and mothers.
Changing out nutes (DWC) is a creative challenge on drainage and replacement.
When I next redesign (Soon) i will have both sides on a rolling platform that will allow me to slide it out and maintain the plants.
Nice design and well thought out.
My biggest issue is being limited to two flowering plants and trying to find space to train the next flowering group in the same space Im trying to store clones and mothers.
Changing out nutes (DWC) is a creative challenge on drainage and replacement.
When I next redesign (Soon) i will have both sides on a rolling platform that will allow me to slide it out and maintain the plants.
Nice design and well thought out.
I have a similar set up. Two rooms with a small space for mechanical/res. Fans are set up so I can move air between the rooms. This keeps the heat up when lights are off. I can also move air outside the room by changing the hoses. So at anytime by removing a vent hose to a new location I have control of temp and smell. mechanical area stays cold so my res temps stay down
Toker1
New member
Ok... so the lower section would make a good clone or seedling room if you can get some t5 cfls in there.
I would recess the middle wall and just remove a section( see attached sketch). This will still support the structure while allowing the light to pass through. This will be your flower room. Then you can set up your 80cm tent for veg. (But due to the small size, you will still need to do a few weeks of veg in the wardrobe cabinet).
I would recess the middle wall and just remove a section( see attached sketch). This will still support the structure while allowing the light to pass through. This will be your flower room. Then you can set up your 80cm tent for veg. (But due to the small size, you will still need to do a few weeks of veg in the wardrobe cabinet).
Attachments
Toker1 Thanks, been working on a new sketch. Also thinking about what RagWeedDWC said about having the pots on a rolling platform, which I could, the roller "fittings" are still on the wardrobe, not sure if it would hold the pots or if they would be too heavy. I love all the ideas you've given me! Thanks a ton! Also, dont mind the pots in the sketch, I'm not going to use those specific ones, just couldn't find any better suited model.
