I recently wrote down my process which works the majority of the time.
The key for me was to think about what a seed in the wild would want to grow and simulate that environment. Tricking the seed into thinking its under a loose layer of soil in a warm moist environment.
Gear - Ziplock bag, coffee filter, seed, spray bottle, water, PH +/-, PH tester, sharpie, tent (lights fan ect), heat mat (MOST IMPORTANT), temp controller, cotton towel.
Process -
Wash your hands really good!
Write strain and date on the outside of the ziplock bag.
Balance the PH of the water in the spray bottle to somewhere between 6.0 and 6.5.
Spray the inside of the ziplock bag with water.
Open the coffee filter (cut to shape if needed) and place the seed in the middle.
Close the filter and spray the filter to wet it.
Put the filter in the bag and spray the shit out of it some more. Note - you do want to drain excess water from the bag, it should not be soaking wet.
Place the towel on the heating mat inside the tent and under the light.
Set the temp controller to 81 F with a heating differential of 2 degrees.
Place the ziplock bag with the filter/seed on top of the towel.
Make sure the ziplock bag is open and not sealed, the seed needs to breathe.
Fold the towel over the top of the bag, blocking the majority of the light.
Place the temp probe under the bag, but above the towel.
Set light to 18/6.
Keep the bag moist, but not soaking for the next few days.
Open the bag, spray it with water, then drain excess and place the bag back. This should be done every few hours to let in fresh air.
If possible run a humidifier or two in the tent.
The goal is to keep the seed and environment very moist.
After a day or two the seed will pop and the white tail will start growing.
Once you are comfortable with the progress move it into a small container.
Ckbrew - coffee filters wont tear the taproot like paper towels do!
