GrowWeedEasy.com
You're browsing as a guest. Sign up to join the conversation, share your grows, and get help from thousands of fellow growers — it's free and takes less than a minute.
demoralized here.....
- Thread starter Weedfreak
- Start date
Bluey
Well-known member
Clones 100 to 150
Seedlings 250 to 350
Vegetative stage 350 to 550
Flower stage 550 to 1000
The above is a rough guide, depends on strain and environment, EC etc.
You need to read this
https://www.growweedeasy.com/basics
Seedlings 250 to 350
Vegetative stage 350 to 550
Flower stage 550 to 1000
The above is a rough guide, depends on strain and environment, EC etc.
You need to read this
https://www.growweedeasy.com/basics
Last edited:
As it is now, I 'm in a 10'x12' prefab shed that I ran electric to. It also serves as my studio space. I have fans and keep the windows open. I also have a portable AC/Dehumidifier/Fan floor unit. Last winter, I kept warm with a ceramic 400W heater. It kept a baseline 40degrees F on the really cold nights. I have the feeling, the lights will help keep it warm for the day, but I'm thinking what about is how to control the heat loss /ventilation. I don't want to waste energy and was wondering how to best deal with that.
Rootsruler
New member
Yep! I wonder if his tap root has even hit bottom yet.......
So now, I'm wondering if I should switch to a 12/12 light schedule. My Purple Chemdawg photo is older than my Game Changer autos, yet the younger Game Changers are starting to flower. THe Purple Chemdawg hasn't shown any signs of flowering. Should I go to a 12/12 or should I keep them on an 18/6?
I put everything on 12/12. I'll figure out something for the seedling/clones tomorrow. THanks.
I got my 24"x24"x48" grow tent with my seedlings and clones in it. I'm a bit confused over all the holes that are in the sides. I figured out the top hole(light cord) the bottom hole(heating pad cord). But the side holes are confusing me. I get that one is for a exhaust hose. But what are the other two for? One is 4" dia. the others are all 6"dia. I'm going to the big box store to get a fan right now until I can afford a nice one. Any and all comments/advice are welcome and thank you.
Rootsruler
New member
Top hole is traditionally where you run your exhaust duct. Side holes near the top are for whatever you need like cords or you can run ducting from there too. Bottom holes can be used for cords or for more air input. Side flaps are for air input.
Gingerbeard
New member
They are for however you need to use them.
My 2x3x4.5 was built for a closet. It sat in a corner and fit with only a few inches to spare under a shelf. The vents on back, top, and one side were useless to me as they were against a wall. Cables and venting went through the one open side.
6" holes are usually for venting. If you can't use a 6" to vent, the 4" will hold muffin fans and are enough to vent that tent closed, with the light off.
My 2x3x4.5 was built for a closet. It sat in a corner and fit with only a few inches to spare under a shelf. The vents on back, top, and one side were useless to me as they were against a wall. Cables and venting went through the one open side.
6" holes are usually for venting. If you can't use a 6" to vent, the 4" will hold muffin fans and are enough to vent that tent closed, with the light off.