A few months back I got really interested in growing my own bud. I was so grateful to have found GWE, I read every page, I bought the book, read every bit of that (yes I am a bit of a nerd), a great anecdotal story in the book inspired me to go totally organic. Using the generous guidance of GWE, I have assembled a tent (photo attached). It is 4x4x6.5 feet in size, and by my calculations, determined I needed 400CFM of circulation in order to replace the entire tent's air the suggested 3 to 5 times per minute. It ended up being a fan/filter system that weighed close to 80lbs!! So I added wooden support to the tent (see photo). After firing up the fan it sounded like an airplane landing, so it quickly became obvious that I needed a fan speed controller, so I ordered one, tried it and it was actually noisier. I did a bit of research and found out that the fan speed controller suggested by Amazon is not the proper type, given the duct fan's motor type, after doing a bit of research, I got a Variac (photo attached), I definitely suggest this for duct fan speed control, at 50% power, it is whisper quiet.
I got my seeds, and started by soaking them for 14 hours in water, then put them into Rapid Rooters with a heating pad below it, and temperature controller, I put an extra rapid rooter in the tray and put the thermal couple in it to monitor grow medium temp. That was one week ago, after just a few days they were ALL in various stages of sprout . They ALL now look like the attached photo . Here are my questions:
1. I started the sprouts with a dome - but the "soil" temp got way too high, so I propped up to allow some circulation. but there was no humidity increase plus I was worried the dome was impeding the light, some of them are really leggy...the question is should I put the dome back?? If so, how long should I leave it on?
2. I worry that the rapid rooters don't provide any nutrients, should I be transferring them to cups with soil now??? GWE suggested that the seedling can stay in the rapid rooter until roots begin to emerge from the bottom, would it be better for them be transferred to soil now?
3. How long can I leave the plants under the fluorescent light?
4. I plan to use LEDs for the Veg and Flower phases, my plan is to use 4 450 Viparspectra Reflector series light fixtures, that would deliver 50W per sq/ft, less than the suggested 60W/sqft, are the 4 450s enough?
Thank you all so much for the many contributions to this forum, I really enjoy reading it!!!!
I got my seeds, and started by soaking them for 14 hours in water, then put them into Rapid Rooters with a heating pad below it, and temperature controller, I put an extra rapid rooter in the tray and put the thermal couple in it to monitor grow medium temp. That was one week ago, after just a few days they were ALL in various stages of sprout . They ALL now look like the attached photo . Here are my questions:
1. I started the sprouts with a dome - but the "soil" temp got way too high, so I propped up to allow some circulation. but there was no humidity increase plus I was worried the dome was impeding the light, some of them are really leggy...the question is should I put the dome back?? If so, how long should I leave it on?
2. I worry that the rapid rooters don't provide any nutrients, should I be transferring them to cups with soil now??? GWE suggested that the seedling can stay in the rapid rooter until roots begin to emerge from the bottom, would it be better for them be transferred to soil now?
3. How long can I leave the plants under the fluorescent light?
4. I plan to use LEDs for the Veg and Flower phases, my plan is to use 4 450 Viparspectra Reflector series light fixtures, that would deliver 50W per sq/ft, less than the suggested 60W/sqft, are the 4 450s enough?
Thank you all so much for the many contributions to this forum, I really enjoy reading it!!!!
Comment