I got some Potassium Phosphate KH2PO4 and was wondering what to do with it. Came across an article that showed a boost in germination rate. But they added a bit of H2O2 with the water.
I used rain water with a 23 ppm/pH 6.6 start
20mM of H2O2 or, 2.35 mL/gr of 35%, 23 mL/gr of 3% per Liter
1 gr/1ppm KH2PO4 and another with 2 gr/2ppm per Liter
And one with the standard of my well water. 455 ppm and 7.4 pH which is what I usually do.
I soaked them in the solution for 24 hrs then went to paper towels saturated in their individual solutions. Placed vertically in the dark. Room temp 68F or so.
Quite frankly I'm amazed. The well water one was the only to sink. The others all had bubbles attached from the dissolved O2. Repeated dunking did no good. After 24 hr the only one to crack was the well water one. It appears the soaking in the solution was a waste and should have gone straight to the paper towels.
I then put them on paper towels separate from each other and placed the tray vertically. After another 24 hrs (48 total) they all were cracked open and all showing a root nub. Pic of all three at bottom.
wll 1ppm
2ppm
After another 24 hrs (72 hr total, 48 on the paper) the 1ppm sprout was out of the gate and in the lead by a wide margin. The 2ppm one was close behind with the well water one pulling up the rear.
Well 1ppm2ppm
At 96 hrs total and 3 days on the paper towels the 1ppm one is way ahead and even showing a bit of red on the root base, 2ppm is not far behind and the well water one again strolling along.
So today I planted them in 16 oz solos with ProMix Bx and watered with their original solutions. Fingers crossed. This is where they usually fail for me at the initial transplant.
And does the picture loading on this site suck. Sorry for the ill edited post.
I used rain water with a 23 ppm/pH 6.6 start
20mM of H2O2 or, 2.35 mL/gr of 35%, 23 mL/gr of 3% per Liter
1 gr/1ppm KH2PO4 and another with 2 gr/2ppm per Liter
And one with the standard of my well water. 455 ppm and 7.4 pH which is what I usually do.
I soaked them in the solution for 24 hrs then went to paper towels saturated in their individual solutions. Placed vertically in the dark. Room temp 68F or so.
Quite frankly I'm amazed. The well water one was the only to sink. The others all had bubbles attached from the dissolved O2. Repeated dunking did no good. After 24 hr the only one to crack was the well water one. It appears the soaking in the solution was a waste and should have gone straight to the paper towels.
I then put them on paper towels separate from each other and placed the tray vertically. After another 24 hrs (48 total) they all were cracked open and all showing a root nub. Pic of all three at bottom.
wll 1ppm
2ppm
After another 24 hrs (72 hr total, 48 on the paper) the 1ppm sprout was out of the gate and in the lead by a wide margin. The 2ppm one was close behind with the well water one pulling up the rear.
Well 1ppm2ppm
At 96 hrs total and 3 days on the paper towels the 1ppm one is way ahead and even showing a bit of red on the root base, 2ppm is not far behind and the well water one again strolling along.
So today I planted them in 16 oz solos with ProMix Bx and watered with their original solutions. Fingers crossed. This is where they usually fail for me at the initial transplant.
And does the picture loading on this site suck. Sorry for the ill edited post.
Comment