Drooping clones

[Mass117]

This is my first time cloning. They’re 6 days in the process and now they’re dropping with some yellowing? Details and pictures are below. Thoughts? Concerns? Anything helps! Thank you ✌️

Been following the cloning instructions on this site along with tips from my local hydro growing store. Spraying twice a day on the branches and into the lid. Starting day 4, Been cracking vents 1/4 per day, and they’re currently 75% open. Planing to open vents 100% tomorrow. The branches are fairly large with plenty of leaf growth. Was collected a little late (1 week into bloom). I’m assuming they’re lacking nutrients than what they’re used to so I thought it was time to add a light dosage of various nutrients of General Hydroponics: veg. Grow, nectar, armor-si, and rapid start (root grower). Also, was doing 24/0 hour lights (cfl & led) for good measures to speed root growth. Just in case if they were “light stressed,” I started doing 18/6 hours of light today as well.

[JDU]

They dont look too bad- I would definitely stop spraying them. Just keep the dome wet. & take the dome off now n then & let em breathe. Get some air in there & avoid WPM. The vent just isn't enough.

[Toker1]

Most people don’t let the medium dry out enough and end up with pathogens due to stagnant water. What medium are they in?
no nutes until they have roots
Spraying twice per day at day 6 is too much. No need to grow roots when the leaves are getting all the water they can handle all the time.
by day 3-4 I have removed the dome completely. On aeroponic cloning systems I never use a dome.

[SoOrbudgal]

Drowned