Hello,
I have been using Promix HP I was told forom the hydroponics store where I purchased it from that there is 100% no nutrients in it. Im using the General HYdroponics FloraGro, Micro and bloom.
After I add the 3 part mix I Use PH down to make it 6.0.
Now I have been having problems with the plants big time something is very wrong.
So I flushed one of the plants and I tested the run off water for PPM & PH and the PPM was over 3000 and the PH was comming out not to bad 5.8. Now I did a test with the Promix HP I filled up a fabric pot and ran plan water at 6.0 through it and tested the PPM it was over 1500? and the PH was comming out lower so how should I be using the Promix.
Any tips would be a big help.
I have been using Promix HP I was told forom the hydroponics store where I purchased it from that there is 100% no nutrients in it. Im using the General HYdroponics FloraGro, Micro and bloom.
After I add the 3 part mix I Use PH down to make it 6.0.
Now I have been having problems with the plants big time something is very wrong.
So I flushed one of the plants and I tested the run off water for PPM & PH and the PPM was over 3000 and the PH was comming out not to bad 5.8. Now I did a test with the Promix HP I filled up a fabric pot and ran plan water at 6.0 through it and tested the PPM it was over 1500? and the PH was comming out lower so how should I be using the Promix.
Any tips would be a big help.
Comment