Ez clone diy humidity etc

[RobM]

Hey

So made myself a small ezclone type thing. First time using it. Ive read a shit load but still unsure...

water temp is about 23 -26 (when it gets to 26 i add ice) air temp is abput 23c but humidity is down at 40% ... ec is .31 (202 ppm..) thats tap water.... pH is 6.1 ... 3x 27w cfl for lights.

4 clones (3x bubbas gift... one unknown) 2 days in atm

now will the humidity be an issue with this as ive read clones like high humidity.... they are in a closet with insol on 3 sides (insol is insulation with a reflective backing... sorta like mylar but this was free ) thr 4th side is the back of the mirror (not reflective)

Thanks in advance...
Rob

[Obi-Wan]

Your light and temp look ok, it's best to stay slightly below 23c when cloning. I would adjust your pH to 5.6-5.8. I take clones every 45 days and I get a 95% rooting rate with that pH range. I clone without a humidity dome and have had good results in lower humidity so I wouldn't worry too much about humidity so long as the water temp and pH are correct.

[RobM]

Sweet cheers.. ill drop the pH tonight when i recheck it. Water temp is the worst to keep. That bloody pump heats up too much.. was at 26 this morning. Dropped the water and added fresh..

[Obi-Wan]

Try hooking it up to a timer so it sprays for 30 seconds and rests for 1 minute. The pump won't run long enough to heat up.

[RobM]

Sweet.. ill try that.. i think i have a spare relay for my arduino thats monitoring it all. Didnt think of that one. Need some decent misters. The ones i can buy off the shelf in australia suck. Going to order some ezclone misters and sde if they are better (amazon as ezclone are trying to charge 175$ US for shipping for 25 heads lol)

[RobM]

15 on 15 off (only timer i could find without spending shit loads) and still getting 25-26c :/ might have to do some wiring and automate it with the arduino :/ 1 on 5 off is what im going to go with.. i guess other option is to use a chiller it seems overkill haha