Announcement

Collapse
No announcement yet.

Gorilla glue topping

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Gorilla glue topping

    I have clones from a GG plant that do not have even pairs of growth nodes. The mother plant had same growth pattern. It's hard to pick a place to top the Clones with odd ball branching. Any advice?

    #2
    Same here with my first two grows. Post picks.
    The clones I've had often start off asymmetrical re branch arrangement, and balance out over time. So you need to determine how that pattern will evolve over time.
    I find it easier to FIM than top for that reason. I've done both and FIM gives me much more benefits. Harder to do right, but worth learning the skills.
    I use a rounded, sharpened #11 Exacto blace and scoop out the offending bits under 10X magnification.
    Lots of good info on GWE about how to do it.
    Good luck.

    Comment


      #3
      Mature plants and cuts off of mature plants have staggered node growth. Completely normal and always happens. I typically top a clone about 8 nodes up and strip off bottom 2 then top the top most again so the bottoms catch up then put in flower whenever after that
      Current Grows:

      GSC and SWEET TOOTH (flowering)

      Platinum LED P600 x 2 (380 w draw at the wall each)
      4'x4'x7' grow tent
      General Organics Go Box
      ProMix HP
      1>3>7 gal smartpots
      Well water PH 6.38

      SOUR BUBBLE, SOUR STRAWBERRY, LIFESAVER, GHOST OG x LEMON, BUBBA KUSH in veg

      Comment

      Check out our new growing community forum! (still in beta)

      Subscribe to Weekly Newsletter!

      Working...
      X