FIM'ing done right?

[Woodsman67]

Day 50 of flower. Today is last feed and water, I have been feeding molasses only last 2 feedings, today is same then I will allow it to basically dry...

[Woodsman67]

After a couple of failed attempts at cloning and dealing with some side issues with my health, I may actually still have something to grow and show. Day...

[Woodsman67]

Still looking beautiful. Not a typical clean trained manifold but I like it...

[Woodsman67]

I actually stepped back to rethink cloning. Still hoping to start one this weekend. Alot can grow in a solo cup in 60 plus days

[Woodsman67]

Definitely. They do start going soft and limp after a while but still manage to hold together so I use those for either give away plants or outside b...

[Woodsman67]

This is a beautiful flower. I am definitely biased. 39 days today...

[Woodsman67]

These were vegged 8 weeks.

[Woodsman67]

That's beautiful and crazy. Keep us posted on this, I haven't had any do that indoors

[Woodsman67]

They seem to have flower sights on the fim'ed farther apart along the stem as well. Yeah not ecstatic about this type of growing...

[Woodsman67]

I FIM'ed several limbs this grow, I notice I have way more flower sites, but they are smaller than those not fim'ed. Is this a normal tradeoff? If so,...

[Woodsman67]

This failed. Probably first time I had 100% failure since I actually learned the basics. My big issue is in the media used, but thanks to all the ideas...

[Woodsman67]

When I first started indoors I was using 5 gal buckets with drainage holes, and still managed to overwater. Airpots made it almost impossible to over...

[Woodsman67]

I've had this discussion with friends over the years. Most say leave anything alone on flowers. I've gotten to the point it's like this, If the stem is...

[Woodsman67]

Getting fatter. 3 to 4 weeks to go...

[Woodsman67]

Thanks! One of my next projects.

[Woodsman67]

I think it's been 3 days. All 3 are still upright. So that's good...

[Woodsman67]

When I water, I wait until plants literally start asking. I'll show you what I mean. Pictures below just before water and an hour or so after. I have...

[Woodsman67]

I thought I put it in there, when I clean my hardware, scissors, cups, whatever, I use peroxide. Just prior to cutting I wipe scissors with alcohol...

[Woodsman67]

Obi-Wan, I always use hydrogen peroxide to clean everything, but I will be changing things. Thanks for your input!...

[Woodsman67]

Unfortunately yes. It turns out usually. I'm not highly confident in it but I have time