Announcement
Collapse
No announcement yet.
Is this WPM?
Collapse
X
-
My grow is outdoor and tomorrow is supposed to be a sunny day. Thanks for the tip! Did you have a ratio of milk to water?
-
If there’s is no mould, just keep eye on it every day. This is what I would do.
And I have had success with milk and water spray when battling the WPM
-
Well, I looked under the microscope and it looks like there's no mould on the buds. Even though some leaves are fairly covered. Does that make sense? The infected plant isn't quite ready for harvest so I'll keep an eye on it. Maybe I should do that milk spray if it's not coming down for 3 days?
Leave a comment:
-
With a microscope it should be pretty easy to see the difference between trichomes and the WPM. I understand if this was without a loupe or microscope.
But again if you are unsure, then wash. Just thinking it would be a little wast, in my opinion if the WPM is not on the buds
-
I'll use my pocket microscope to check if the wpm has spread to the buds. It's hard to tell it apart from the trichomes.
Leave a comment:
-
I've seen it done with two different recipies both had same ingredients just separate buckets for one of them
1... two 5 gallon buckets about 3/4 full water tap water is fine but you can use whatever
1st bucket is 1 cup hydrogen peroxide (brown bottle from store) 1/2 cup baking soda (not powder) 1/2 cup lemon juice
2nd bucket plain water to rinse
Gently swish the buds in the 1st approximately 1 minute then the 2nd app. 30 seconds being careful not to ram them into the bottom or sides.... hang em with direct airflow from a fan until no more water is dripping then dry as normal
2.... was all the same except you use three buckets 1st with the baking soda and lemon juice 2nd with peroxide 3rd plain water... method was the same as above
-
If you don’t have wpm on the buds, don’t wash them.
I harvested lots of plants which had some WPM on the leaves. Never had a cured bud with WPM.
think it will be a waste just to wash them if you don’t have any on the buds
Leave a comment:
-
Seems like washing them is the surest method. I assume if left untreated, the mould will spread across the cured buds, so it can't be ignored. I read about a wash which is 3 parts – bucket 1 is 1-2 grams of baking soda per liter of water, 2 is 10 mL of peroxide per liter of water and the last is just clean water. Does this sound good?
Leave a comment:
-
I would use peroxide 2-4 tbsp in a 1 qt hand sprayer. Just don't soak the buds unless they have wpm because the moisture will stay in them no since risking rot getting inside the buds unless the wpm is already there. I would also consider washing your buds when you harvest
Leave a comment:
-
Thanks for the confirmation. Tonight was when I was taking one of the two plants down. That one is a bit smaller and has no mould. The other is a few days away. I took the large sun leaves off them today, removing most of the mould off the affected plant. I can't tell if there's mould on the buds, they have a lot of trichomes. If I'm harvesting it in three days, should I still spray it with diluted vinegar? As well, what ratio would you suggest?
Leave a comment:
Leave a comment: