Announcement

Collapse
No announcement yet.

Batter up! Amnesia Haze Autoflower

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • RagWeedDWC
    replied
    Amnesia Haze Auto Vendor ILGM Day Weeks
    Start Date 2/3/2020 Lights Spider 100 and Blurple 600 Grow 8 1
    Flower Start Ratio Flower #VALUE!
    Nutrients Future Harvest Yield
    Date 2/11/2020
    I started three seeds, to make sure one was good and all three sprouted (Kinda). MY GSCE is coming along so fast, I think I will keep one seed in the areo until GSCE is cut down and move it over to grow chamber. Having two to finish off before fishing season.
    Last edited by RagWeedDWC; 02-11-2020, 10:26 AM.

    Leave a comment:


  • RagWeedDWC
    commented on 's reply
    I fish along those who pulled a living out of the sea, hats off to them

  • Anoney
    replied
    Just started a few Amnesia Haze Autos from RQS myself. I'll be following you on this one, good luck! 😊

    Leave a comment:


  • JohnEmad
    commented on 's reply
    Thanks for the feedback. I am using some of FH calmag to precharge my coco and add xtra if needed. Once I am finished with my Remo nutes I want to try something else to compare. Remo I am using 1/4 strength of recommended on my current grow. Use 1/2 to 1/3 last grow and it was too strong.
    Last edited by JohnEmad; 02-09-2020, 12:02 AM.

  • RagWeedDWC
    commented on 's reply
    I just switched to FH, I was using GH until someone enlightened me. I used FH last year for a short period of time to try to recover from an issue, and it worked well. I switched to GH because who the fug knows, just seem like a good one to go to. I did learn not to use the recommended feedings and it worked well at 1/3 strength. I liked FH because of PH control, I seem to have a huge issue with it.

  • JohnEmad
    commented on 's reply
    RagWeedDWC how do you like the Future harvest Nutes?

  • RagWeedDWC
    commented on 's reply
    :-) Cool Beans

  • SoOrbudgal
    replied
    Cool beans stretcher out

    Leave a comment:


  • RagWeedDWC
    commented on 's reply
    This should be another tumble weed, last one for the season. Some one mentioned leaning the plants over and horizonal to the lights. Sounds like a fun experiment :-) going to give it a shot and grow it across the two spaces.

  • SoOrbudgal
    commented on 's reply
    Grow little gal show us what you got!

  • RagWeedDWC
    replied
    Amnesia Haze Auto Vendor ILGM Day Weeks
    Start Date 2/2/2020 Lights Spider 100 and Blurple 600 Grow 2 0
    Flower Start Ratio Flower #VALUE!
    Nutrients Future Harvest Yield
    Date 2/4/2020
    Date Action Time Stage Notes Grow Water Level PPM PH
    Finally have a seed started, and we are off to the races.

    Leave a comment:


  • RagWeedDWC
    commented on 's reply
    Link for air pump, they also have a 150 that may be better for the buckets. https://www.amazon.com/Tetra-Whisper.../dp/B0002563QI

  • RagWeedDWC
    commented on 's reply
    I found elsewhere that drooping leaves in hydro usually means not enough oxygen, It may be that your blue stones are not putting out enough micro bubbles (Just a swag). You may try getting a 4 or 6 inch disk and trying that per bucket. In my buckets they are long enough to put two in My air pumps will force air into a pond 6 foot deep so they have lots of pressure and are quite. (Whisper AP 300), they have two outlets so use one pump per tote, good luck and thanks for the kind comments on my setup

  • Growgood88
    replied
    Mine had a good root system so after alot of dropping and drowning I put the last couple inches through netpot myself and am hoping it straight end up it has been dropping 4 days so I tried that. Ain't messing with roots anymore it came from soil and is a bit shocked I'm new at it. If it dies I'll just take the hit and start over the right way.

    Leave a comment:


  • RagWeedDWC
    commented on 's reply
    I keep mine about an inch or a little more above the top of the water, Until the roots are good and established I use the spitter to keep it fed.

Check out our new growing community forum! (still in beta)

Subscribe to Weekly Newsletter!

Working...
X