Announcement
Collapse
No announcement yet.
From Kief to Hash...
Collapse
X
-
Hi Mazzariman
I use the 4x7 Ryot box and thinking of getting the 7x7 for more kief. As for the divider this video will explain it's use.
-
Howdy FarmBuck. Would you recommend the 4x7 or 7x7 box? Why is there a divider in the 7x7 box? Just curious. I've never used something like this before. Thanks!
-
thanks man and i had to look him up but now I got some reading material...very cool
-
Nice !! With some practices you will be as good as Frenchy Cannoli hey ?
-
was just over 8 grams. i may heat again slightly and squeeze it once more. but still a nice block of hash1 Photo
- Likes 3
Leave a comment:
-
Here’s some of my last batch of bubble hash. Been curing for about 3 1/2 months and just keeps getting better and better!1 Photo
- Likes 4
Leave a comment:
-
I use the dry ice method to separate the resin from the trim (I usually get about an 8:1 yield). Then I press the resin into pucks with a stainless sleeve press that you whack with a rubber mallet. You can stop there if you smoke with a pipe. However, I prefer to smoke using the pin and glass method and the raw pressed kief is a little too crumbly for that. So I add a little heat and pressure to my pucks with a clothing iron. I set the iron on its lowest heat setting. I wrap the pucks in parchment paper and place that inside a damp wash rag then iron with firm pressure for a few minutes. This firms the hash up so you can stick it on the pin without it breaking. Up until now I have only done this with trim. One of these days I going to try it with flower.
- Likes 5
Leave a comment:
-
Remember it take a few days before the water evaporate...
Leave a comment: