Announcement

Collapse
No announcement yet.

Sour Diesel Clone

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Tika
    replied
    Oh sorry! Seed source? Brand of coco? Germinating in what?
    im with Green...start again.
    hang in there.

    Leave a comment:


  • Tersky
    commented on 's reply
    Thats what i was afraid of. I'll start germinating! Thanks Green!

  • Green75
    replied
    I am afraid by the time you nurse those back to health you can have new ones healthier and ready to go

    Leave a comment:


  • Tersky
    replied
    So i need a consensus. Should i toss the clones and just start over or give them another week. They mostly look dead but have a little green in some of the leaves. Green75, Royal Nugs what do you think? Not opposed to starting over. Everything is a learning experience for me.

    Leave a comment:


  • Tersky
    replied
    UPDATE: I think i boo-booed. They dont look too good. Put them in Coco Pearl with ph'd water with Cal-mag...first time in coco. Been in there a week and a half....thinking of tossing and just starting another seedling..

    Leave a comment:


  • Tersky
    replied
    Day 4:

    Bigger clone is rooting into starter plug. Had used cloning gel on that one. Small clone had no root growth and had not used cloning gel on that one. Scraped, soaked and dipped smaller clone into rooting gel and put back into starter plug. Leaves still continue to turn yellow on both. No vegetative growth but was not expecting any.

    Leave a comment:


  • Wannabebotanist23
    commented on 's reply
    Yeah i would ALWAYS recommend cloning in dirt, its the easiest and cheapest

  • Green75
    replied
    You good...

    Leave a comment:


  • Tersky
    replied
    So should i be worried that the leaves are starting to yellow? Or is that normal when doing clones?

    Leave a comment:


  • Green75
    commented on 's reply
    Cut that cup smaller......so it's not so tall

  • Tersky
    replied
    Oh ya. Put it in a plug in small solo cup. I dont like the setup tho. kinda awkward. Just ordered some small plastic pots and coco mix and am going to remove the DWC for this.

    Leave a comment:


  • Green75
    replied
    What did you do with short clone

    Leave a comment:


  • Tersky
    replied
    Ok i think im going to do coco with these clones in fabric pots. Does anyone have recommendations as far as pot size? I was thinking the 1 Gal for the cloning/veg box then move to tent in 5 Gal pots. Is 5 gal large enough to finish the grow? this is my first time doing a non DWC setup so i want to make sure i get everything i need instead of frantically realizing i need more/bigger pots.

    Leave a comment:


  • Green75
    commented on 's reply
    Put in plug in solo cup...done

    Cut cup down not so tall

    Dude tons of room in that little box to root two clone...and more

  • Tersky
    commented on 's reply
    I need to make another lid to my reservoir. Only one hole in top....or....if i had two small pots with coco (smartpots?)....ugh i wish i didnt just sample my recently harvested master kush.....thinking.....

Check out our new growing community forum! (still in beta)

Subscribe to Weekly Newsletter!

Working...
X